- To prevent water waste, built-in Quick Response technology instantly shuts down irrigation as soon as it starts raining
- Instant Quick Response rain shutoff and freeze shutoff at 37°F
- Maintenance-free design with integrated battery for wireless models
- Adjustable vent ring allows for shorter or longer reset period
Set Wireless Rain-Clik Transmitter Address
Only needed if the transmitter or receiver is replaced, or purchased separately.
-
Remove power from the controller. Press and hold the Bypass button on the receiver.
-
While holding the button, restore power to the controller. The sensor LED should turn amber, indicating the receiver is ready to pair.
-
Press and hold the Quick Response button on the transmitter for 5 seconds.
-
Within 4 seconds, the receiver LED should turn red, confirming that the address was successfully learned.
-
Release the transmitter button. The LED should turn green to confirm final pairing success.
Note: When power is restored, the LED may stay red while syncing (up to 1 hour). To sync immediately, press and hold the “Test” button for 5 seconds, then release. The LED will change to green.
Reviews
There are no reviews yet.